Installation Guide

COLD

HOT

OFF

of the washer should face up.

into the base of the facet as shown. The tapered side

faucet body followed by the rubber gasket, and insert

faucet body. Slide the tapered metal washer onto the

2. Remove the lock nut and brass spacer from the

process.

catch any water that may drip during the installation

Place a small bucket below your workspace to Tip:

way to the right.

completely shut oﬀ by turning the shutoﬀ valves all the

1. Ensure that the water supply below your sink is

crack or break the copper mounting post.

complete tightening. Do not overtighten, which can

wrench to give the lock nut no more than a ¼ turn to

Hand tighten, then use an adjustable Important:

or plumber’s tape to the threads before tightening.

lock nut before securing. Apply a bit of thread sealant

as shown. Insert the provided rubber O-ring into the

4. Attach the sprayer hose to its copper mounting post

an adjustable wrench.

shank until hand-tight to secure. Finish tightening using

faucet body. Thread the locknut back onto the threaded

beneath the sink, slide the brass spacer back onto the

3. Insert the faucet into its mounting hole. From

Installation

Kitchen Faucet Installation Instructions

KITCHEN FAUCET INSTALLATION

１

PAGE 1
KITCHEN FAUCET INSTALLATION Installation 1. Ensure that the water supply below your sink is completely shut oﬀ by turning the shutoﬀ valves all the way to the right. Tip: Place a small bucket below your workspace to catch any water that may drip during the installation process. 3. Insert the faucet into its mounting hole. From beneath the sink, slide the brass spacer back onto the faucet body. Thread the locknut back onto the threaded shank until hand-tight to secure.
PAGE 2
KITCHEN FAUCET INSTALLATION 5. Disassemble the provided hand sprayer hose weight by removing the two screws with a Phillip’s screwdriver. From beneath the counter, measure 15” down the hose from the faucet body. The weight will need to be mounted at this location. Clamp the two sides of the weight together and tighten the screws to secure. 7. Once installation is complete, turn the main water supply back on from underneath your sink. Check for any leaks underneath. ON 6.