Installation Sheet
INSTALLATION INSTRUCTIONS
3
TOOLS REQUIRED
1. All electrical work and materials
must comply with the National
Electric Code (NEC), the Occu-
pational Safety and Health Act
(OSHA), and all state and local
codes. Canadian installations must
comply with Codes Canada and
provincial codes.
2. Use copper conductors only.
3. DO NOT install the heater directly
above bathtub or sink. DO NOT install
in shower stall area. Manufacturer
recommends installing your heater
at least 2 feet (61 cm) away to
prevent contact with water.
4. Heater must be installed in a wall
can:
Model CS - wall can models
CC or CCSM
Model CST - wall can model
CTC (WC1)
5. DO NOT install the heater in a floor,
below a towel bar, behind a door, or
anywhere the air discharge may be
blocked in any manner.
6. To reduce the risk of fire, do not
store or use gasoline or other
flammable vapors and liquids in the
vicinity of the heater.
7. Connect grounding lead to ground-
ing screw provided. Keep all foreign
objects out of heater.
8. CAUTION – High temperature,
risk of fire, keep electrical cords,
drapery, furnishings and other
combustibles at least 3 feet (0.9
m) from the front of the heater and
away from the side and rear.
Tape Measure
Straight and Phillips
Screwdrivers1½" Wood ScrewsWire Strippers Wire Connectors
½" Cable Clamp
Connector
Volt Meter
Drill and Drill Bits
Stud Finder
A multi-purpose tool or something to cut your existing drywall or gypsum board.
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®®
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®®
Z
I
R
C
O
N
®
®
Hammer
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®®
Z
I
R
C
O
N
®
®
Z
I
R
C
O
N
®®
PARTS OF YOUR HEATER
built-in thermostat
(optional)
heater element
fan and
motor
high-temperature
safety shutos