Owner's Manual

c
L
controller allows the Can to gradually incrcase to a higher speed. This
prevcnts cold air from blowing into the passenger compartment.
If \/ou want the blowcr fan to run only at a ked high speed, press the
(upper) button
until you sce HI on the display.
If you want the fan speed to be automatic, but vou like the fan speed to be
higher than the AUTO setting. just press the fan button until HI/AUTO is
shown on thc display.
If you want the blowcr to ~LIII only at a fixed low speed, press the (lower)
huttot1 until LO is shown on the display.
Press this button to
removc fog or frost
from the windshield.
This setting sends most of the airflow to the windshield with only a small
amount to the floor outlets.
The fan speed will work automatically to maintain vour rsqussted interior
temperature.
If you need more air directed to yourbindshield, you should
select a higher fan speed.
in some cold start conditions, the AUTO blower fan speed may be limited
until the
engine cooling system warms up. This is normal to prevent
windshield fogging.
It will help if you first clear any ice and snow from the hood and the air
inlet
(it’s between the hood and the windshield).