Installation Guide
Turn o power to your appliance before you remove or replace the knobs.
Work with one knob at a time to ensure you don’t mix up replacement pieces.
Make sure you check the writing on each of your knobs (and/or bezels) and set them out in the
order you will replace them. This will help ensure you don’t put them on in the wrong order.
IMPORTANT!
Instructions for Replacing Knobs with Illuminating Bezels
Instrucciones En Español | Instructions En Français:
www.cafeappliances.com/kit-instructions
¼” Hex Tool
(included)
13 mm Hex Tool
(needed only for some models)
Tools You Will Need:
I. Removing the Current Knob and Bezel
1. Make sure all knobs are in the OFF position.
2. Choose which knob you will work with first.
3. Remove the knob by grasping the sides and pulling away from the appliance
until the knob is free from its shaft. You may have to wiggle it slightly as you pull
(fig. 2).
4. Next, identify the bezel attachment screws from the bezel image (fig. 3).
5. Using ¼” Hex tool, remove the two bezel attachment screws. Do NOT remove
any other visible screws.
6. If the bezel has an attachment nut, you will need to remove it using the 13 mm
Hex tool.
7. You should be able to remove the bezel from the appliance front after the screws
and nut have been removed.
II. Installation of the Replacement Knob and Bezel
1. Install the bezel by positioning it around the shaft with the indicator notch at the
top. Tabs on the back of the bezel will insert into the top and bottom notches. If
your model required you to remove the attachment nut, replace the nut by
tightening it with the 13 mm Hex tool until snug. Be careful not to strip the nut.
2. Using the ¼” Hex tool, screw in the bezel attachment screws to hold the bezel in
place.
3. Match the replacement knob with the knob you’ve removed—make sure they
have the same writing and markings.
4. Hold the replacement knob so that OFF is at the top and it lines up properly with
the shaft.
5. Push the knob onto the shaft as far as possible so it fits snuggly.
Repeat the above removal and installation steps for each knob until they have all
been removed and replaced.
fig. 3
fig. 2
fig. 1
Indicator notch
REMOVE
REMOVE
Indicator notch
REMOVE
REMOVE REMOVE
Your bezel will resemble one of these two configurations.
Remove only the screws indicated.