Installation Guide

Turn o power to your appliance before you remove or replace the knobs.
Work with one knob at a time to ensure you don’t mix up replacement pieces.
Make sure you check the writing on each of your knobs (and/or bezels) and set them out in the
order you will replace them. This will help ensure you don’t put them on in the wrong order.
IMPORTANT!
Instructions for Replacing Knobs with Bezels with Keyhole Center
Instrucciones En Español | Instructions En Français:
www.cafeappliances.com/kit-instructions
Tools You Will Need:
I. Removing the Current Knob
1. Make sure all knobs are in the OFF position.
2. Choose which knob you will work with first.
3. Remove the knob by grasping the sides and pulling away from the appliance until
the knob is free from its shaft. You may have to wiggle it slightly as you pull (fig. 1).
4. Identify the bezel attachment screws from the bezel image (fig. 2).
5. If your knobs included a ¼” Hex tool, you will use it to remove the two bezel
attachment screws. Otherwise, use a Phillips head screwdriver to remove the two
bezel attachment screws. Only remove the two bezel attachment screws. Do NOT
remove any other visible screws.
6. You should be able to remove the bezel from the appliance front after the screws
have been removed.
REMOVE
REMOVE
REMOVE
REMOVE
Indicator notch
Bezel with keyhole center
Bezel alignment tool
Valve shaft
II. Installing the Replacement Knob and Bezel
1. Install the bezel first by positioning it around the shaft with the indicator notch at
the top.
2. Position the bezel alignment tool over the shaft. Make sure the flat side of the tool
is toward the bottom, matching the flat side of the shaft.
3. Press the bezel alignment tool onto the shaft until it is snug. (fig. 3)
4. Screw in the bezel attachment screws to hold the bezel in place.
5. Remove the bezel alignment tool.
6. Match the replacement knob with the knob you’ve removed—make sure they have
the same writing and markings.
7. Hold the replacement knob so that OFF is at the top and it lines up properly with
the shaft (fig. 4).
8. Push the knob onto the shaft as far as possible so it fits snuggly.
Repeat the above removal and installation steps for each knob until they have all
been removed and replaced.
Your bezel will resemble one of these two configurations.
Remove only the screws indicated.
fig. 3
fig. 4
fig. 2
fig. 1
Bezel Alignment Tool
(provided with your knobs if necessary)
Phillips Head Screwdriver ¼” Hex Tool
(provided with your knobs if necessary)