Installation Guide

FOR WARRANTY ISSUES OR QUESTIONS, CONTACT CAHABA AT (866) 837-2550.

PULL-OUT KITCHEN FAUCET

Installation Instructions

INSTALL THE SOAP DISPENSER

1. Insert the body assembly through the selected hole in the sink (a).

2. Secure the body assembly to the sink with the nut.

3. From under the sink, screw the bottle onto the body assembly shank.

4. Insert the pump down into the body assembly.

CONNECT THE WATER

1. Thread the nut on the supply line onto the outlet of the water supply

valve and tighten with a wrench. Do not overtighten.

X IMPORTANT: The hot side inlet tube is indicated by a label. Avoid twisting

wires together or placing the wires close to each other and damaging.

FINISHING

1. After installation is completed, turn on the hot and cold water supplies.

Check for leaks.

2. Pull the hose assembly out of the spout and remove the spray head by

unscrewing it from the hose in a counterclockwise direction. Be sure to

hold the end of the hose down into the sink and turn the faucet on to the

warm position where it mixes hot and cold water.

3. Flush the water lines for one minute. This ushes away any debris that

could cause damage to internal parts.

4. Check for leaks. Re-tighten any connections if necessary, but do not

overtighten.

5. Reinstall the spray head by hand tightening it back onto the spray hose.

(a) Insert body

assembly

(b) Secure with nut

Attach supply line to

water supply valve.