Use and Care Manual
Top Gun Barbecue Grill
LTR50001121, Rev. B
Appendix
www. ca l a me b bq . c o m
33
Using a wrench, remove the ori ce for the infrared b.
burner.
Apply pipe compound to the tting threads where c.
you will place the new ori ce.
Screw on the correct ori ce for your grill until it is d.
nger tight.
Tighten the ori ce with the wrench.e.
If you have dual infrared burners, repeat the f.
previous steps for the second burner.
Replace the back cover.g.
Replace the infrared burner orifi ces2.
Unscrew the back cover from the grill and lift it a.
up and under the grill hood.
You will need:
Either a 13mm or 10mm open end wrench•
One #50 ori ce (for single infrared burner)•
OR
Two #54 ori ces (for dual infrared burners)•
OR
One #52 ori ce (for single infrared burner)•
Pipe compound suitable for natural gas•
You will need:
7mm wrench, socket, or nut driver•
One or two 1.75mm ori ces (depending on •
your side burner)
Pipe compound suitable for natural gas•
Gas Conversion (continued)
Replace the side burner orifi ces3.
Remove the grate, burner cap and burner a.
diffuser from the side burner.
Using a 7mm wrench, remove the ori ce for b.
the burner.
Apply a small amount of pipe compound to c.
the ori ce threads.
Screw in the ori ce until it is nger tight.d.
Tighten the ori ce with the 7mm wrench.e.
If you have dual side burners, repeat the f.
previous steps for the second burner.
Mark the rating plate4.
After conversion has been completed, mark the rating
plate as NG with an indelible marker.