Use and Care Manual
P4, P5, and P6 Barbecue Grills
LTR50001137, Rev. K
Appendix
www.calamebbq.com
33
d. Screw on the correct orice for your grill until
it is nger tight.
e. Tighten the orice with the wrench.
f. If you have dual infrared burners, repeat the
previous steps for the second burner.
g. Replace the back cover.
You will need:
• Either a 13mm or 10mm open end wrench
• One #50 orice (for single infrared burner)
OR
• Two #54 orices (for dual infrared burners)
OR
• One #52 orice (for single infrared burner)
• Pipe compound suitable for natural gas
You will need:
• 7mm wrench, socket, or nut driver
• One or two 1.75mm orices (depending on
your side burner)
• Pipe compound suitable for natural gas
a. Remove the grate, burner cap and burner
diffuser from the side burner.
b. Using a 7mm wrench, remove the orice for
the burner.
c. Apply a small amount of pipe compound to
the orice threads.
d. Screw in the orice until it is nger tight.
e. Tighten the orice with the 7mm wrench.
f. If you have dual side burners, repeat the
previous steps for the second burner.
4. Mark the rating plate
After conversion has been completed, mark the rating
plate as NG with an indelible marker.
2. Replace the infrared burner orices
a. Unscrew the back cover from the grill and lift
it up and under the grill hood.
b. Using a wrench, remove the orice for the
infrared burner.
c. Apply pipe compound to the tting threads
where you will place the new orice.
3. Replace the side burner orices