Repair manual

SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
1
F3C CURSOR ENGINES
Print P2D32C005 E Base - May 2007
SECTION 4
Overhaul and technical specifications
Page
GENERAL CHARACTERISTICS 3.............
ASSEMBLY CLEARANCE DATA 5............
ENGINE OVERHAUL 11.....................
ENGINE REMOVAL AT THE BENCH 11........
REPAIR OPERATIONS 12....................
CYLINDER BLOCK 12.......................
- Checks and measurements 12...............
- Cylin der liners 13.........................
- Replacin g cylinder liners 14.................
- Removal 14.............................
- Assembly and checking protrusion 14.........
- Crankshaft 15............................
- Measuring the main journals and crankpins 16...
- Preliminary measurement of main and big
end bearing shell selection data 17............
- Select in g the main bearing and big end
bearing shells 18..........................
- Replacing the timing control gear and
the oil pump 24..........................
- Checking main journal installation clearance 24..
- Checking crankshaft end float 25.............
ASSEMBLING THE ENGINE ON THE BENCH 26.
DIAGRAM SHOWING THE UNDERBLOCK FIXING
SCREWS TIGHTENING ORDER 27.........
PISTON CONNECTING ROD ASSEMBLY 28....
- Removal 28.............................
- Measuring the diameter of the pistons 29......
- Conditions for correc t gudgeon
pin-piston coupling 29.....................