Repair manual

2
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E
Page
- Piston rings 30............................
- Connecting rod 31........................
- Checking connecting rod alignment 32.........
- Mounting the connecting rod - piston assembly 32
- Mounting the piston rings 32................
- Fitting the connecting rod-piston assembly into
the piston liners 33........................
- Piston protrusion c h eck 33..................
- Checking assembly clearance of big end pins 34..
CYLINDER HEAD 34........................
- Valve removal 34.........................
- Checking the planarity of the head on
the cy linder block 34.......................
- Removing deposits and checking the valves 34...
- Valve 35................................
- Valve guides 35...........................
- Replacing of valve guides 36.................
- Replacing - Reaming the valve seats 36.........
- Replacing injector holder cases 36............
- Removal 36..............................
- Assembly 37.............................
Page
- Checking injector protrusion 38..............
- Camshaft 39.............................
- Checking cam lift and pin alignment 39.........
- Bushings 40..............................
- Replacing camshaft bush es using
beater 99360499 41.......................
- Removal 41..............................
- Assembly 41.............................
VALVE SPRINGS 42.........................
- Fitting the valves and oil seal ring 42...........
ROCKER SHAFT 43.........................
- Shaft 43.................................
- Rocker 43...............................
TIMING GEAR 44..........................
- Camshaft drive 44.........................
- Idlergearpin 44
..........................
- Idler gear 44.............................
- Twin in termediate gear pin 44...............
- Twin idler gear 44.........................
- Replacing the bushings 44...................
TIGHTENING TORQUE 45..................