Repair manual

47577
16798
60521
Figure 13
Figure 14
Figure 15
Figure 16
Position the parts 99360706 (2) and the plate 99360728 (4)
as shown in the figure, checking that the plate (4) rests on the
cylin der lin er correct ly.
Screw down the nut of screw (1) and extract the cylinder
liner (3) from the crankcase.
Always replace the water seals (3, 4 and 5).
Fit the adjustment ring (1) on the cylinder liner (2). Lubricate
the bottom of it and mount it in the c y linder assembly using
the appropriate tool.
Check the protrusion of the cylinder liners with tool 99360334
(2) and tightening the screw (1) to a torque of 225 Nm .
Using the dial gauge 99395603 supplied as standard with the
dial gauge base 99370415 (3), check that the protrusion of
the cylin der liner over the supporting face of t h e cylinder
head is 0.045 - 0.075 mm (Figure 16); if this is not so, replace
the adjustment ring (1) (Figure 14), supplied as a spare part
with several th icknesses.
On completing assembly, lock t h e cylinder liners (1) to the
crankcase (2) wi th the pins 99360703 (3).
Assembly and checking protrusion
Figure 17
CYLINDER LINER PROTRUSION
49017
The adjustment ring (1) is supplied as a spare part
with the following thicknesses: 0.08 mm - 0.10 mm
- 0.12 mm - 0.14 mm.
60520
0.045 to 0.075
Replacing cylinder liners
Removal
NOTE
14
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E