Repair manual

47595

47596

Figure 41

Figure 42

Place the half-bearings (1) on the main bearings in the

underblock (2).

By means of suitable equipment (1) apply silicone LOCTITE

5970 IVECO No. 2992644 to the block, as shown in the

figure.

Sealant application diagram

Fit the underblock within 10’ of the application of the

sealant.

Figure 43

49021

47581

Figure 44

Figure 45

Fit the sub- engine block and use a dynamometric wrench (2)

to tighten the outer hexagonal-grooved screws (1) to 30 Nm

according to the diagrams on the following page.

Fit the underblock by means of a suitable hoist and h ooks (1).

49022

47579

Figure 46

Close the inner screws (1) to 120 Nm torque by means of

a dynamometric wrench (3), then with two further angular

phases 60° +55°, using t ool 99395216 (4). Tighten again the

outer screw s (1, Figure 45) with 60° angular closing, using

tool 99395216 (3, Figure 45).

ASSEMBLING THE ENGINE ON THE

BENCH

NOTE

Use new screws whenever the crankcase is refitted.NOTE

SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS

F3C CURSOR ENGINES

Base - May 2007 Print P2D32C005 E