Repair manual

47506
47505
47507
Figure 84
Figure 85
Figure 86
Camshaft
Checking cam lift and pin alignment
When the camshaft (4) is on the tailstock (1), ch ec k alignment of supporting pin (3) using a centesimal gauge (2); it must not
exceed 0.030 mm. If misalignment exceeds this value, replace the shaft.
In order to check installation clearance, measure bush inner diameter and camshaft pin (1) diameter; the real clearance is obtained
by their difference.
If clearance exceeds 0.135 mm, replace bushes and, if necessary, the camshaft.
Place the camshaft (4) on the tailstock (1) and check cam lift (3) using a centesimal gauge (2).
1
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
39
F3C CURSOR ENGINES
Print P2D32C005 E Base - May 2007