Repair manual

The surface of the bushings must show no sign of seizing or
scoring; replace t hem if they do.
Measure the inside diameter of the bushings with a bore
gauge.
60627
Figure 87
Figure 88
MAIN DATA OF THE CAMSHAFT AND TOLERANCES
The surfaces of the supporting pins of the shaft and those of the cams need to be extra smooth.
Whereas, if they show any signs of seizing or scoring, you should replace the shaft and the relevant bushings.
MAIN DATA OF THE BUSHINGS FOR THE CAMSHAFT AND SEATS ON THE CYLINDER HEAD
* Bushing inside diameter after driving in
Bushings
If you fin d a higher value than the tolerance, replace them.
To remov e and fit the bushings, use the app r op r ia te drif t
99360499.
60626
40
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E
TOLERANCES FEATURE SUBJECT OF TOLERANCE SYMBOL
DIRECTION Perpendicularity
⊥
POSITION Concentricity or coaxiality
SWING Circular oscillation
↗
CLASS OF IMPORTANT ASCRIBED TO PRODUCT CHARACTERI STICS SYMBOL
CRITICAL ©
IMPORTANT
⊕
SECONDARY
⊝