Repair manual

Figure 89
A. Drift with seat for bush in gs to insert/extract. - B. Grub sc rew for positioning bushings. - C. Reference mark to insert
seventh bushing correctly. - D. Reference mark to insert bushings 1, 2, 3, 4, 5, 6 correctly (red marks). - E. Guide bushing. -
F. Guide line. - G. Guide bushing to secure to the seventh bushing mount. - H. Plate fixing yellow bushing to cylinder head.
-I.Grip.-L.Extensioncoupling.
Figure 90
The sequence for removing the bushings is 7, 6, 5, 4, 3, 2, 1.
The bushings are extracted from the front of the single seats.
Removal does not require the drift exten sion for bushings 5,
6 and 7 and it is not necessary to use the guide bushing.
For bushings 1, 2, 3 and 4 it is necessary to use the extension
and the guide bushings.
Position the drift accurately during the phase of removal.
Removal
Figure 91
Assembly
1 Position the bushing to insert on the drift (A) making the
grub screw on it coincide with the seat (B) (Figure 89) on
the bushing.
2 Position the guide bushing (E) and secure the guide
bushing (G) (Figure 89) on the seat of the 7
th
bushing
with the plate (H).
3 While driving in the bushing, make the reference mark (F)
match the mark (M). In this way, when it is driven h ome,
the lubrication hole on the bushing will coincide with the
oil pipe in its seat.
The bushing is driven home when the 1
st
red reference
mark (D) is flush with th e guide bushing (G).
Assemble the drift together with the extension.
To insert bushings 1, 2, 3, 4 and 5, proceed as follo ws:
71723
Figure 92
To insert the bushing (6), proceed as follows:
- Unscrew the grip (I) and the extensio n (N).
- Position the extension (N) and the guide bushing (E) as
showninthefigure.
- Repeatsteps1,2,3.
Rear
Rear
77795
71725
Replacing camshaft bushes using beater 99360499
107217
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
41
F3C CURSOR ENGINES
Print P2D32C005 E Base - May 2007