Repair manual

TIMING CONTROL COMPONENT PARTS

1. Camshaft - 2. Bushing - 3. Pin - 4. Articulated rod -

5. Camshaft con trol gear - 6. Idler gear - 7. Twin idler gear

- 8. Drive shaft driving gear.

86925

* This measurement is obtained after assembling.

TIMING GEAR

Camshaft drive

101602

Figure 104

Figure 105

Figure 106

101601

* This measurement is obtained after assembling.

Idlergearpin

Idler gear

Twin intermediate gear pin

Twin idler gear

Replacing the bushings

Bushings (2) can be replaced when they are worn . Put up the

bushing, then bore it to obtain the diameter shown on

Figure 105 or Figure 106.

The bushing must be dri ve n into the gear by following

the dire ction of the arrow and setting the latter to the

dimension shown on Figure 105 or Figure 106.

Rated assembling play between gear bushin gs and pins:

Figure 105 — 0.045 ÷ 0.075 mm

Figure 106 — 0.045 ÷ 0.085 mm.

NOTE

SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS

F3C CURSOR ENGINES

Base - May 2007 Print P2D32C005 E