Repair manual

46
SECTION 4 - OVERHAUL AND TECHNICAL SPECIFICATIONS
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E
P
A
R
T
TORQUE
P
A
R
T
Nm kgm
Screw fastening the engine supporting bracket to the flywheel case
Stage 1: pretightening 100 (10)
Stage 2: an gle 60°
Camshaft gear capscrews ♦
Stage 1: pretightening 60 (6)
Stage 2: an gle 60°
Screw fixing phonic wheel to timing system gear ♦
8.5 ± 1.5 (0.85 ± 0.15)
Exhaust manifold capscrews •
pretightening
tightening
40 ± 5
70 ± 5
(4 ± 0.5)
(7 ± 0.5)
Capscrews, connecting rod caps ♦
Stage 1: pretightening 60 (6)
Stage 2: an gle 60°
Engine flywheel capscrews ♦
Stage 1: pretightening 120 (12)
Stage 2: angle 90°
Screws fixing damper flywheel: ♦
First phase pre- tightening 70 (7)
Second phase closing to angle 50°
Screws fixing intermediate gear pins: ♦
First phase pre- tightening 30 (3)
Second phase closing to angle 90°
Screw fixing connectin g rod for idle gear
24.5 ± 2.5 (2.45 ± 0.25)
Screws fixing oil pump 24.5 ± 2.5 (2.45 ± 0.25)
Screws fixing crankshaft gasket cover 24.5 ± 2.5 (2.45 ± 0.25)
Screws fixing fuel pump/filter 19 (1.9)
Screw fixing control unit mount to crankcase 19 ± 3 (1.9 ± 0.3)
Screws and nuts fixin g tu rboc harger •
pre-tightening
tightening
35
46
(3.5
(4.6)
Screws fixing water pump to crankcase 22 ± 2 (2.2 ± 0.2)
Screws fixing water pump to crankcase 25 (2.5)
Screw fixing aut omatic tensioner to crankcase 26 ± 3 (2.6 ± 0.3)
Screw fixing fixed tensioner to crankcase 50 ± 5 (5 ± 0.5)
Screws fixing fan mount to crankcase 105 ± 5 (10.5 ± 0.5)
Screws fixing starter motor 74 ± 4 (7.4 ± 0.4)
Screwsfixingairheatertocylinderhead 30 ± 3 (3 ± 0.3)
♦ Before assembly, lubricate with UTDM oil
• Before assembly, lubricate with graphitized oil