Repair manual

Figure 38
Figure 39
Figure 40
Figure 41
Figure 42
Figure 43
101606
Loosen screws (3), then remove sump (1) complete with
spacer (2) and seal gasket (4).
60515
- By means of metal ropes, lift the cylinder head (1).
- Remove the seal (2)
60514
- Fit the plugs 99360180 (1) instead of injectors.
- Remove the camshaft (2).
- Unscrew the fixing screws on the cylinder head (3).
102935
To extract the pump injector from the engine block, using the
tool proceed as follows:
- Hook up the detail (3) of the tool illustrated in the figure
to the injector pump (4);
- fit part (2) on part (3), resting the former on the cylinder
head;
- tighten the nut (1) and extract the pump injector (4) from
theengineblock
116814
Apply tool 99360553 (1) to the rocker holder shaft (5) and
remove the shaft (5) from the cylinder head.
104257
- Disconnect the electrical connections from the pump
injectors.
- Unscrew the screws (1) fixing the rocker arm shaft.
Only for F3BC0684A*E001 engine
14
SECTION 3 - INDUSTRIAL APPLICATION
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E