Repair manual

Figure 44
Figure 45
Figure 46
Figure 47
Figure 48
Check that the pistons 1 -6 are exactly at the T .D.C.
Put the gasket (2) on the crankcase.
Mount the cylinder head (1) and tighten the screws as shown
in Figs. 43 - 44 - 45.
60515
!
Lubricate the thread of the screws with engine oil
before assembly.
Key on the gasket (1), mount the key 99346250 (2) and,
screwing down the nut (3), drive in the gasket (1).
60564
Using the centring ring 99396035 (2), check the exact position
of the cover (1). If it is wrong, proceed accordingly and lock
the screws (3).
60563
Engine assembly
101607
Loosen the screws, then remove suction strainer (1).
104784
Loosen screws (3), then remove sump (1) complete with
spacer (2) and seal gasket (4).
Only for F3BC0684A*E001 engine
SECTION 3 - INDUSTRIAL APPLICATION 15
F3C CURSOR ENGINES
Print P2D32C005 E Base - May 2007