Repair manual

119493
Fit the support shaft (2) of the intermediate gear in its seat.
Fasten the fastening screws (1) and tighten at a torque of 115
Nm.
Figure 49
Figure 50
Diagram of the tightening sequence of the screws fixing the
cylinder head.
- Pre-tightening with the torque w r e nch (1):
1
st
phase: 60 Nm (6 kgm).
2
nd
phase: 120 Nm (12 kgm).
60565
61270
Figure 51
60566
- Closing to angle with tool 99395216 (1):
3
rd
phase: angle of 120°.
4
th
phase: angle of 60°.
α
Figure 52
Mount the oil pump (4), the intermediate gears (2) together
with the link rod (1) and lock the screws (3) in two phases:
- pre-tightening 30 Nm.
- closing to angle 90°.
60567
α
Figure 53
Replace the o-ring (1) if the support shaft of the intermediate
gear was removed.
119495
Figure 54
16
SECTION 3 - INDUSTRIAL APPLICATION
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E