Repair manual

Figure 55
Fit the intermediate gear (1) on the support shaft. Fasten the
fastening screws (2) and tighten at a torque of 115 Nm.
119496
Figure 56
App ly LOCTI TE 5970 IVECO n˚ 2992644 silicone on the gear
housing, using appropriat e tools (1), as shown in the figure.
The sealer string (1) diameter is to be 1,5 ±
104311
0.5
0.2
Mount the gear housing within 10 min. of applying the
sealant.
NOTE
Only for F3BC0684B*E003 engine
The assembly of the gear casing may be hindered by
the intermediate gear. In this case, move the gear
casing beyond the intermediate gear being careful not
to damage the sealant on the part already fitted on
the crankcase.
NOTE
Using a torque wrench, tighten the highlighted screws with the
following sequence and tightening torques:
6 screws M12 x 1.75 x 35 63 Nm
8 screws M12 x 1.75 x 100 63 Nm
2 screws M12 x 1.75 x 120 63 Nm
2 screws M12 x 1.75 x 160 63 Nm
119497
Figure 57
1 screw M12 x 1.75 x 130 63 Nm
:
Figure 58
Key on the gasket (1), mount the keying device 99346251 (2)
and, screwing down the nut (3), drive in the gasket.
104282
SECTION 3 - INDUSTRIAL APPLICATION 17
F3C CURSOR ENGINES
Print P2D32C005 E Base - May 2007