Repair manual

Mount the gear housing within 10 min. of applying the

sealant.

NOTE

Only for F3BC0684A*E001 engine

The assembly of the gear casing may be hindered by

the intermediate gear. In this case, move the gear

casing beyond the intermediate gear being careful not

to damage the sealant on the part already fitted on

the crankcase.

NOTE

Using a torque wrench, tighten the highlighted screws with the

following sequence and tightening torques:

6 screws M12 x 1.75 x 35 63 Nm

8 screws M12 x 1.75 x 100 63 Nm

2 screws M12 x 1.75 x 120 63 Nm

2 screws M12 x 1.75 x 160 63 Nm

119498

Figure 59

1 screw M12 x 1.75 x 130 63 Nm

Figure 60

App ly LOCTI TE 5970 IVECO n˚ 2992644 silicone on the gear

housing, using appropriat e tools (1), as shown in the figure.

The sealer string (1) diameter is to be 1,5 ±

Figure 61

104785

0.5

0.2

Key on the gasket (1), mount the keying device 99346251 (2)

and, screwing down the nut (3), drive in the gasket.

104787

SECTION 3 - INDUSTRIAL APPLICATION

F3C CURSOR ENGINES

Base - May 2007 Print P2D32C005 E