Repair manual

104286
Figure 64
Figure 65
Figure 66
Position the crankshaft with the pistons 1 and 6 at the top dead
centre (T.D.C.).
This situation occurs when:
1. The hole with reference mark (5) of the engine flywheel
(4) can be seen through the inspection window.
2. The tool 99360612 (1), through the seat (2) of the engine
speed sensor, enters the hole (3) in the engine flywheel (4).
If this condition does not occur, turn the engine flywheel (4)
appropriately.
Remove the tool 99360612 (1).
- Fit the idle gear (1) back on and lock the screws (2) to the
required torque.
60571
- Apply the gauge 99395219 (1). Check and adjust the
position of the link rod (3) for the idle gear. Lock the screw
(2) to the required torque.
60570
Fit the camshaft (4), positioning it observing the reference
marks (→) as shown in the figure.
Lubricate the seal (3) and fit it on the shoulder plate (2).
Mount the shoulder plate (2) with the sheet metal gasket (1)
and tighten the screws (5) to the required torque.
73843
Fitting camshaft
Figure 67
20
SECTION 3 - INDUSTRIAL APPLICATION
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E