Repair manual

60572
Figure 68
Figure 69
Position the gear (2) on the camshaft so that the 4 slots are
centred with the holes for fixing the camshaft, without fully
locking the screws (5).
Using the dial gauge with a magnetic base (1), check that the
clearance between the gears (2 and 3) i s 0.073 — 0.195 mm;
if this is not so, adjust the clearance as follows:
- Loosen the screws (4) fixing the idle gear (3).
- Loosen the screw (2, Figure 65) fixing the link rod. Shift
the l ink rod (3, Figure 65) to obtain the required
clearance.
- Lock the screw (2, Figure 65) fixing the link rod and
screws (4, Figure 68) fixing the idle gear to the required
torque.
Figure 70
104243
Fit the seals (1) (2) (3) on the injectors.
Before refitting the rocker-arm shaft assembly, make
sure that all the adjustment screws have been fully
unscrewed.
Apply the tool 99360553 (1) to the rocker arm shaft (2) and
mount the shaft on the cylinder head.
116814
5
Fitting pump-injectors
Fitting rocker-arm shaft assembly
Mount:
- The injectors (1) and, using a torque wrench, lock the
bracket fixing screws to a torque of 26 Nm.
- The crosspieces (2) on the valve stem, all with the largest
holeonthesameside.
Figure 71
104260
NOTE
SECTION 3 - INDUSTRIAL APPLICATION 21
F3C CURSOR ENGINES
Print P2D32C005 E Base - May 2007