Repair manual

22
SECTION 3 - INDUSTRIAL APPLICATION
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E
Figure 72
Figure 73
104261
Lock the screws (2) fixing the rocker-arm shaft as follows:
- 1
st
phase: tightening to a torque of 80 Nm (8 kgm) with
thetorquewrench(1);
- 2
nd
phase: closing with an angle of 60° using the tool
99395216 (3).
Mount the electric wiring on the electro-injectors.
104316
α
Using the tool, turn the engine flywheel (1) in the direction of
rotation of the engine so as to take the piston of cylinder no.1
to approximately the T.D.C. in the phase of combustion.
This condition occurs when the hole with one reference mark
(4), after the hole with two reference marks (5) on the engine
flywheel (1), can be seen.
Camshaft timing
(For F3CE0684B*E003)
Figure 74
SCHEME OF SCREW T IGHTENING SEQUENCE
SECURING ROCKER ARMS
Screw screws (1 - 2 - 3) until rocker arms are brought to
contact relating seats on cylinder head, tighten the screws
according to sequence indicated in figure operating in two
steps as indicated in successive figure.
70567A
Camshaft timing
(For F3CE0684A*E001)
Figure 75
104789
Using the tool, turn the engine flywheel (1) in the direction of
rotation of the engine so as to take the piston of cylinder no.1
to approximately the T.D.C. in the phase of combustion.
This condition occurs when the hole with one reference mark
(4), after the hole with two reference marks (5) on the engine
flywheel (1), can be seen.