Repair manual

Fasten the cover (3) and fasten the screws (2) at the specified
torque.
The one-way filter (5) must be fitted with the two
reinforcement bars visible as shown in the figure.
Fit the timing cover (1).
Figure 84 Figure 85
85480
Fit the blow-by casing (7) with corresponding seal and tighten
the screws (8) at the specified torque.
Fit the filter (5) with the corresponding seals (4 and 6).
Tighten the fastening screws on the rocker arm cover
(1) in the order shown in figure 79.
!
45363
17 14 13 1 4 5 8
18
19
20
16 15 12 2 3 6 7
11
10
9
DIAGRAM OF ROCKER ARM CAP FIXING SCREWS
TIGHTENING SEQUENCE
Figure 86
85481
Fit the breather body (1) within 10 after applying the
sealant.
NOTE
Apply LOCTITE 5970 on the breather body (1) forming a
bead (2) as shown in figure ∅ 1,5 +
0,5
0,2
26
SECTION 3 - INDUSTRIAL APPLICATION
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E