Repair manual

Figure 92
Fit heat exchanger (2) with its respective gasket, then tighten
fastening screws (1) to the torque specified and according to
the sequence indicated in Figure 92.
Fittheoilfilters(1)ontherelevantsupportsasfollows:
- oil the seals;
- screw the filters down for the seals to make contact with
the supporting bases;
- tighten the filters to a torque of 35 to 40 Nm.
101605
45361
DIAGRAM OF HEAT EXCHANGER FIXING SCREWS
TIGHTENING SEQUENCE
Figure 93
Fit, with the respective gaskets.
- the fuel pump (2);
- fuel filter unit (3) with its respective pipes (1);
- connect the pipes (1) to the fuel pump (2).
104254
Figure 94
Figure 95
Fit the hydraulic coupling (2) onto the flywheel casing.
Tighten the fastening screws (1).
Tighten the screws (1) at a torque of 45 Nm.
119490
28
SECTION 3 - INDUSTRIAL APPLICATION
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E