Repair manual

Figure 100
Figure 101
119480
119484
Fit the turbocharger (2) on the exhaust manifold making sure
that the seal (4) is positioned between the two parts.
Position the shims (3) on the fastening screws (1) and tighten
them at a torque of 70 Nm
Fasten the nuts (5) and tighten them at a torque of 45 Nm.
119483
Fit the oil delivery pipe (1) onto the turbocharger and fasten
with the fitting (2) on the filter unit and with the screws ( 6 ) to
the turbocharger itself.
Insert the oil return pipe (4) in the crankcase and fasten it with
the screws (3).
The fasten the pipe (4) to the turbocharger by means of the
screws (5).
Figure 102
Figure 103
119481
Position the clamps (1) and (2) respectively on the
turbocharger and on the power turbine.
Fit the connection manifold (3) between turbocharger and
power turbine.
Fasten the manifold to the two turbines by means of the
clamps (1) and (2).
Tightening the fixing screws to the prescribed torque, mount:
- the starter motor (1);
- the control uni t (2) and its support;
- the oil dipstick (3) in the crankcase.
Check the state of the flexible elements of the control
unit support and change them if they have
deteriorated.
30
SECTION 3 - INDUSTRIAL APPLICATION
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E