Repair manual

104269
Figure 15
Distribution pulse transmitter
Features
Vendor BOSCH
Torque 8 ± 2Nm
Resistance 880 ÷ 920 Ω
This induction type sensor located on the camshaft generates signals obtained from the magnetic flow lines that close through the
6 plus 1 phase teeth of a sound wheel mounted on the shaft.
The electronic center uses the signal generated by this sensor as an injection step signal.
Though electrically identical to engine rpm sensor mounted in the camshaft in is NOT interchangeable with it as it cable is shorter
and it features a larger diameter.
This sensor’s air gap is NOT ADJUSTABLE.
48
SECTION 3 - INDUSTRIAL APPLICATION
F3C CURSOR ENGINES
Base - May 2007 Print P2D32C005 E
Description Cable colour
To EDC center pin 9 (Sensor connector ”C”) W
To EDC center pin 10 (Sensor connector ”C”) R