Operation Manual

EN - 23
IMPORTANT:
Remove the two transport screws
on top of the unit before installation.
Otherwise, the player will not work.
Installation
Electronic Connections
1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated.
2. For connections without the ISO connectors, check the wiring in the vehicle carefully before
connecting, incorrect connection may cause serious damage to this unit. Cut the connector,
connect the colored leads of the power cord to the car battery, as shown in the colour code
table below for speaker and power cable connections.
Location
Function
Connector A Connector B
1 Rear Right (+) - Purple
2 Rear Right (-) - Purple / Black Stripe
3 Front Right (+) - Gray
4 Battery 12V(+)/yellow Front Right (-) - Gray / Black Stripe
5 ANT/Amp control/blue Front Left(+) - White
6 Front Left(-) - White / Black Stripe
7 ACC+/red Rear Left (+) - Green
8 Ground/black Rear Left (-) - Green / Black Stripe
Preparation
1. Disconnect battery
Before you begin, always disconnect the
battery negative terminal.
Note:
If the unit is to be installed in a car
eq ui pp ed wit h a n o n- bo ar d dr iv e o r
navigation computer, do not disconnect the
battery cable. If the cable is disconnected,
the computer memory may be lost. Under
these conditions, use extra caution during
installation to avoid causing a short circuit.
2. Remove transport screws
CAUTION:
For proper operation of the player, the
chassis must be mounted within 20° of
horizontal. Make sure the unit is mounted
within this limitation.
3. Remove unit from sleeve
Lift latches on both sides of sleeve to
remove half-sleeve from the unit.
Mounting sleeve installation
1. Slide the mounting sleeve off the chassis.
If it is locked into position, use the removal
tools (supplied) to disengage it.
2. Check the dashboard opening size by
sliding the mounting sleeve into it.
If the opening is too small, carefully cut or
file as necessary until the sleeve easily
slides into the opening. Do not force the
sleeve into the opening or cause it to bend
or bow. Check for sufficient space behind
the dashboard for the unit chassis.
This unit can be installed in any dashboard
with a suitable 183mm(w) x 52mm (h)
opening as shown above. The dashboard
should be 4.75 mm - 5.56 mm thick in order
to be able to support the unit.
3. Locate the series of bend tabs along the
top, bottom, and sides of the mounting
sleeve. With the sleeve fully inserted into
the dashboard opening, bend as many of
the tabs outward as necessary to firmly
secure the sleeve to the dashboard.
4. Place the unit in front of the dashboard
opening so the wiring can be brought
through the mounting sleeve. Follow the
wiring diagram carefully and make certain
all connections are secure and insulated