Operation Manual

EN - 24
Installation
with wire nuts or electrical tape. After
completing the wiring connections, turn the
unit on to conrm operation (vehicle ignition
must be on). If the unit does not operate,
re-check all wiring until the problem is
corrected.
5. Make sure the player is right-side up, then
carefully slide the radio into the mounting
sleeve until it is fully seated and the spring
clips lock it into place.
6. Secure the rear of the unit to the car body
using the mounting bolt and rubber cushion.
7. T est the un it u sin g t he “ Ope ra tio n”
instructions that follow.
Kit Installation
If you r v eh ic le req ui re s t he use of an
installation kit to mount this unit, follow the
instructions included with the installation kit to
attach the unit to the mounting plate supplied
with the kit.
1. Wire and test the unit as outlined in the
Mounting Sleeve Installation instructions.
2. Install the player/mounting plate assembly
to the sub-dashboard according to the
instructions in the installation kit.
3. Replace the dashboard trim panel.
ISO Installation
This unit has threaded holes in the chassis
side panels which may be used with the
original factory mounting brackets of some
vehicles to mount the radio to the dashboard.
Please consult with your local car stereo shop
for assistance on this type of installation.
1. Remove the existing factory radio from the
dashboard or center console mounting.
Save all hardware and brackets as they will
be used to mount the new radio.
2. Carefully unsnap the plastic frame from the
front of the new unit chassis. Remove and
discard the frame.
3. Remove the factory mounting brackets and
hardware from the existing unit and attach
them to the new unit. Do not exceed M5 x
9mm maximum screw size. Longer screws
may dam age compone nts ins ide the
chassis.
4. Wire the new u nit as outlined in the
Mounting Sleeve Installation instructions.
5. Mount the new unit ass embly to the
dashboard or center console using the
reverse procedure of step 1.
Reset
Resetting the unit will erase the time and
preset memories. It should only be activated
upon initial installation after all wiring is
complete, or if there is a malfunction of
any of the switches on the unit. In these
circumstances, pressing the RESET button
will clear the system and return the unit to
default operation.
Fuses
When replacing a fuse, make sure the new
fuse is the correct type and amperage. Using
an incorrect fuse could damage the radio.
Reconnect battery
When wiring is complete, reconnect the
battery negative terminal.
Mounting bolt
Rubber cushion
Transport
screws
Mounting
sleeve
Main unit
Trim plate