Operation Manual

EN - 7
When parking brake applied
1. If 'PRK SW' cable is connected to hand
brake switch, the video display of the TFT
monitor will be controlled by driving status,
system setup and input video sources.
2. When the car is moving ahead, if the
video disc is played, the screen appears
"WARNING!! Engage Parking Brake to
View Video", and blank screen. The above
warning screen will prevent the driver
watching images. The passengers at the
rear seats can watch normally.
When reverse driving
If the rear view video camera is connected,
the unit automatically switches to CAMERA
source during reverse driving. The unit returns
to the original work mode after the reverse
driving is done.
Using an SD/MMC Card
1. Press [ ] button to slide down the
panel, insert an SD/MMC card into the
corresponding slot, the unit will read the
les automatically.
2. To remove the card, you should rst select
another source, in order to avoid damaging
the card, then press the card slightly, and
take off the card after it popped out.
Using a USB Device
1. Push the cap of USB connector to the
left, insert a USB device into the USB
connector.
When connecting a USB device, the unit
will read the les automatically.
2. To remove the USB device, you should
rst select another source, in order to avoid
damaging the USB device. Then take off
the USB device, push the cap to the right.
Basic Operations
USB/SD/MMC Notes
USB functions (ash memory type) MP3 music
play
1. SD/MMC card support
2. USB flash memory 2 in 1 (SD/MMC )
support
3. Fat 12/fat 16/fat 32 is possible
- Fat 12/16 (dir: 200 support, file: 500
support)
- Fat 32 (dir:180 support, le:1500 support)
4. File name: 32 byte/dir name: 32 byte /tag
name: 32 byte
5. Tag (ID3 tag ver 2.0)
- Title/artist/album: 32 byte support
6. Multi card reader not support
7. USB 1.1 support
USB 2.0 support
(It can not support USB 2.0 speed. Just,
get the same speed with USB 1.1)
Not all kinds of USB devices are compatible
with the unit.