Operating instructions

November 2013, W: www.calibreuk.com

T:+44 1274 394125 F: +44 1274 730960 E: techsupport@calibreuk..com 7

3.2.

Introduction

The HQView-2xx units have the input connector on one side of the housing and the output connector as

well as the communication ports on the opposite side. The keypad for controlling HQView-2xx is located

on the input connectors side. The active input is indicated by their corresponding triangles lit green.

1 – Keypad with three keys for OSD menu navigation (Menu, Down and Up).

With the Menu key the OSD menu is activated. The up/down keys are used for OSD menu navigation.

To exit the OSD menu or any submenu navigate go to the Exit item and press the menu key. To access

a submenu navigate to it and press the menu key. To apply a change go to the menu item, press the

menu key and make a parameter change with the up/down key. Confirm the change by pressing the

Menu key. This will also bring you back to the submenu.

The active channel is indicated by the associated green lit triangle(s). This is always the 3G-SDI input.

With the following multiple key presses further functions can be applied:

Keypad unlock: Up/Down

Set output and fallback output mode to VGA: Menu/Up

Mode reset: Menu/Down

Factory reset: Menu/Up/Down

A factory reset can also be applied when pressing the factory reset key combination at power up. The

keys have to be kept pressed for about 10 seconds until the 3GSDI input LED stops flashing. If the keys

are released during that 10 seconds period the system will get into Updater mode (see chapter 5) since

the Menu key is part of this key combination.