Operating instructions

© Calibre UK Limited Issue 2.41 04
th
November 2013, W: www.calibreuk.com
T:[phone] F: [phone] E: techsupport@calibreuk..com 9
3.5. Output
This menu contains adjustments associated with setting up outputs from the unit. Most items are
collected in the Display Type submenu. Use the up and down keys to scroll to the required item and
press the Menu key.
3.5.1. Output Mode
Settings: 640x480, 800x600, 1024x768, 1280x768, 1280x800, 1280x1024, 1360x768, 1366x768,
1400x1050, 1440x900, 1600x1200, 1680x1050, 1920x1200, 720p (1280x720), 1080p (1920x1080),
480p (720x480), 576p (720x576)
Set up the desired output resolution with output mode. The output mode setting should match the native
resolution of the imaging device to avoid double scaling.
3.5.2. Location
Settings: Front Tabletop, Front Ceiling, Rear Tabletop, Rear Ceiling
The image can be flipped to accommodate different projection scenarios as well as screens mounted
upside down.
3.5.3. Optimize for Display
Settings: DVI forced, Optimized, DVI/HDMI
Internally, the display interface processes data at a full ten bits per colour. The colour depth on the DVI-
D output is determined by the supported standard of the attached monitor or device when set to
DVI/HDMI. For DVI 1.0 and HDMI 1.1/1.2 devices it is 24 bit, for HDMI 1.3 compliant devices it is up to
36 bit.
DVI forced will output with 24 bit colour depth irrespective of the supported standard of the attached
monitor.
When the Optimized setting is enabled the output resolution is automatically set to the native screen
resolution of the attached display if the Aspect Ratio menu item was chosen to Scale or when no input is
detected. The colour depth is determined in the same way as when set to DVI/HDMI.
3.5.4. DVI Range
Settings: Default, Limited, Full
When set to Default CEA output modes have limited range, and VESA modes have full range.
Therefore, an incoming limited range mode is either passed through when the output is set to a CEA
output mode or expanded when the output is set to a VESA mode. An incoming full range mode is either
compressed when the output is set to a CEA output mode or passed through when the output is set to a
VESA mode.
If the HDMI/DVI output does not behave as expected, e.g. because the HDMI display is not evaluating
AVInfoFrames properly, the range can be changed manually.
A limited video range is only using the following greyscale for video information - 8 Bit System: 0x10 ..
0xEF, 10 Bit System: 0x040 .. 0x03BF, 12 Bit System: 0x100 .. 0xEFF.