Operating instructions

© Calibre UK Limited Issue 2.41 04
th
November 2013, W: www.calibreuk.com
T:[phone] F: [phone] E: techsupport@calibreuk..com 17
3.9.6. Network Settings
The Network Settings menu allows to configure the HQView-2xx TCP/IP address. Under Address Type
a static or DHCP leased address can be chosen. The static address, Netmask, and Gateway address
need to be entered manually.
The Network Settings menu has a section with information on the DHCP Status and IP address
assigned to the board, as well as the fixed MAC Address programmed into the HQView-2xx. The DHCP
status is Off when static assignment is used or it displays an address when DHCP has leased an
address accordingly or it is None assigned if the lease was not successful.
Note: When changing from DHCP to Static mode or vice versa it is strongly recommended that
HQView-2xx is powered down after such a change, then powered back up, so that it is properly
recognised by other devices on the network.
3.9.7. Factory Defaults
This button let you restore all settings to the default values of the HQView-2xx, thus, provide a means to
get back to a known (good) system state. A requestor will come up and ask to confirm prior to actual
restore.