Installation Sheet

COLD
1 Install Bidet Valve
-Install all thread into bottom of bidet body.
-Place flat rubber washer under bidet body.
-Install flex lines below bidet body. Do not over-tighten.
-Insert bidet body through top of deck and set.
-Place O-ring inside of horseshoe retaining washer and place
over all thread and secure with supplied brass nut.
Flat Rubber Washer
IMPORTANT
All products are engineered to provide quality performance provided
they are installed and operated properly. To fully enjoy the comfort, safety, and reliability of your
new Bidet, please follow the instructions below.
INSTALLATION
INSTRUCTIONS
BIDET
SINGLE HOLE - TWO HANDLE
Please refer to Finish Care Instructions for complete
cleaning information. Wipe frequently with a soft, damp
cloth. Never use acids, harsh abrasives or detergents .
IMPORTANT CLEANING NOTICE
2
NOTE: Flush hot and cold supply lines before
connecting faucets to supply risers. Failure to do so
could result in voiding of warranty.
Lock
Nut
Adjustable
Eye-Screw
Fig. 3
Ball
Rod
Nut
Fig. 2Fig. 1
O-ring
Horseshoe
Retaining Washer
Brass Nut
All Thread
Stopper
Adjustable
Eye-screw
Rubber Washer
Fiber Washers
Brass Nut
Drain
Tailpiece
Drain Collar
Drain
Rim
Cone
Washers
Nut
Ball Rod
Hole Rod
Strap
Lift
Rod
Spring
Clip
Optional
4" Cover Plate
R
Tel: [phone]
Fax: [phone]
Toll Free: 800-822-8855
www.calfaucets.com
California Faucets reserves the right to make modification and specification changes at any time.
Please visit www.calfaucets.com for most current technical data.
Ref. MONOBIDET-INSTL
(V 01) 06/28/06
Installation Instructions
This Fitting is available with an optional 4" cover plate
1 1/4"
2"
Connect flex lines to water supplies.
3
Connect your waste "P" trap to the drain tailpiece.
4
Install pop-up assembly.
-Separate drain collar from pop-up assembly.
-Apply silicon caulking to underside of drain collar. NOTE: Do not use
"Plumbers Putty" or any oil based sealants! Use of anything other
than silicon caulking will VOID the finish warranty.
-Insert drain body from underside through sink. Slowly screw on drain
collar, align with ball rod hole facing back wall, then gently pull down into
sink and firmly tighten brass nut from below.
-Remove tailpiece from drain body and apply teflon tape, approx. 3 to
5 wraps around threads and reinstall into bottom of drain body.
-Insert stopper in collar and hold with eye-screw hole facing back.
If necessary, adjust stopper eye-screw height by loosening lock nut and
rotating counter-clockwise. Tighten lock nut (See Fig. 3).
-Remove spring clip from ball rod.
-Remove nut and cone washers and slide onto end of ball rod.
-Insert ball rod into drain body below so short end of ball rod end fits
in stopper eye-screw hole. Snug ball rod nut (do not over tighten).
Ball rod must move up & down freely (See Fig. 3).
-Insert lift rod through top of spout and then through hole rod strap
underneath sink. Tighten thumb-screw of hole rod strap
against lift rod and connect to ball rod by gently pinching locking
spring clip and sliding one side of spring clip onto ball rod.
-Insert hole strap onto ball rod, then pinch spring clip together to fit
on ball rod.