User Guide
Table Of Contents
- Cambium
- PMP 450 Planning Guide
- Accuracy
- Copyrights
- This document, Cambium products, and 3rd Party Software products described in this document may include or describe copyrighted Cambium and other 3rd Party supplied computer programs stored in semiconductor memories or other media. Laws in the United ...
- Restrictions
- License Agreements
- High Risk Materials
- Safety and regulatory information
- Contents
- List of Figures
- List of Tables
- About This Planning Guide
- PMP support website: http://www.cambiumnetworks.com/support
- Cambium main website: http://www.cambiumnetworks.com/
- Sales enquiries: solutions@cambiumnetworks.com
- Email support: support@cambiumnetworks.com
- Telephone numbers:
- For full list of Cambium support telephone numbers, see:
- http://www.cambiumnetworks.com/support/contact-support
- Address:
- Chapter 1: Planning considerations
- Regulatory planning
- Network migration planning
- Site planning
- Link planning
- Analyzing the RF Environment
- Selecting Sites for Network Elements
- Diagramming Network Layouts
- Grounding and lightning protection
- Configuration options for TDD synchronization
- Data network planning
- Security planning
- Isolating APs from the Internet
- Managing module access by passwords
- Filtering protocols and ports
- Port Lockdown
- Isolating SMs
- Filtering management through Ethernet
- Allowing management from only specified IP addresses
- Configuring management IP by DHCP
- Planning for airlink security
- Planning for RF Telnet Access Control
- Forwarding Downlink PPPoE PADI packets
- Planning for RADIUS integration
- Planning for SNMP security
- Ordering components
- Chapter 2: Legal information
- Cambium Networks end user license agreement
- Acceptance of this agreement
- Definitions
- Grant of license
- Conditions of use
- Title and restrictions
- Confidentiality
- Right to use Cambium’s name
- Transfer
- Updates
- Maintenance
- Disclaimer
- Limitation of liability
- U.S. government
- Term of license
- Governing law
- Assignment
- Survival of provisions
- Entire agreement
- Third party software
- Hardware warranty
- Limit of liability
- Cambium Networks end user license agreement
- Chapter 3: Reference information
PMP 450 Planning Guide
Mounting the GPS receiver (CMM or UGPS) module on the
equipment building
If mounting the GPS receiver on the equipment building, select a position on the wall that meets the following
requirements:
• It must be below the roof height of the equipment building or below the height of any roof-mounted
equipment (such as air conditioning plant).
• It must be below the lightning air terminals.
• It must not project more than 600mm (24 inches) from the wall of the building.
If these requirements cannot all be met, then the module must be mounted on a metal tower or mast.
Mounting the GPS receiver (CMM or UGPS) module on a metal
tower or mast
If mounting the GPS receiver module on a metal tower or mast, select a position that meets the following
requirements:
• It must not be mounted any higher than is necessary to receive an adequate signal from four GPS
satellites.
• It must be protected by a nearby lightning air terminal that projects farther out from the tower than the
GPS receiver module.
• It must meet all the requirements stated in Protection requirements for a mast or tower installation on
page 1-111.
pmp-0047 (March 2014)
1-119