User Guide

Table Of Contents
PMP 450 Planning Guide
GUEST, who has no write permissions and only a limited view of General Status tab
From the factory default state, configure passwords for both the root and admin account at the
ADMINISTRATOR permission level, using the Account => Change Users Password tab. (If you configure
only one of these, then the other will still require no password for access into it and thus remain a security risk.)
If you are intent on configuring only one of them, delete the admin account. The root account is the only
account that CNUT uses to update the module.
After a password has been set for any ADMINISTRATOR-level account, initial access to the module GUI
opens the view of GUEST level.
Table 57 Identity-based user account permissions - AP
Menu
Option
Menu Tab ADMIN INSTALLER TECH
Home
General Status
Session Status
Remote Subscribers
Event Log
Network Interface
Layer2 Neighbors
Configuration
General
IP
Radio
SNMP
Quality of Service (QoS)
Security
Time
VLAN
VLAN Membership
DiffServ
Protocol Filtering
Port Configuration
Syslog
Unit Settings
Statistics
Scheduler
SM Registration Failures
Bridge Control Block
Bridging Table
Ethernet
Radio
VLAN
Data VC
Throughput
pmp-0047 (March 2014)
1-129