User Guide

PMP 450 Planning Guide Glossary
Notifications
This section contains notifications of compliance with the radio regulations that are enforced in various regions.
PMP 450 regulatory compliance
The PMP 450 complies with the regulations that are enforced in the USA and Canada. The relevant
notifications are specified in this section.
PMP 450 FCC and IC notification
U.S. Federal Communication Commission (FCC) and Industry Canada (IC) Notification.
This system has achieved Type Approval in various countries around the world. This means that the system
has been tested against various local technical regulations and found to comply. The frequency band in which
the system operates is ‘license exempt’ and the system is allowed to be used provided it does not cause
interference. The licensing authority does not guarantee protection against interference from other products
and installations.
This device complies with part 15 of the US FCC Rules and Regulations and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation. In Canada, users should be cautioned to take note that high power radars are allocated as primary
users (meaning they have priority) of the 5650 – 5850 MHz spectrum and these radars could cause interference
and/or damage to license-exempt local area networks (LELAN).
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically
radiated power (EIRP) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une
antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le
but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (PIRE) ne dépasse pas l'intensité
nécessaire à l'établissement d'une communication satisfaisante.
3-42
pmp-0047 (March 2014)