Use and Care Manual

REMOTE CONTROL
*
A master button is located on the top left hand side of the insert. This button must be
turned ‘On’ to operate remote control. Turn button to ‘Off’ to disable the use of the remote
control.
Light bulbs may become loose during shipping. If the simulated flame effect is dim or does
not operate properly at first, please ensure that the light bulbs are properly secured in the
sockets(bulbs should be finger tight-do not over tighten). See “Replacing Light Bulb”
section of this man
ual for instructions.
.
1.Press the power button once(The digital screen appears the
.
2. This fireplace insert consists of a fan forced electric heater
with two heater settings,800 watts or 1,500 watts. Press the
button once(the digital screen appears ‘L’), press the
temperature button (the digital screen appears ‘H’),
press it two times,the heate will be turned off,and the
rules is 'L' -'H'-'Off'-and so on. After heater settings( 'L' or 'H' ), it
'- -'.
appears
the available Fahrenheit degrees.
3. This electric fireplace is equipped withatimer ranging from 1
hour to9hours. Press the timer button on the remote control to
desired timer(the digital screen appears from ‘1H’ to ‘9H’ when
settings, and so on). After settings, it appears the available
Fahrenheit degrees.
Remote Control Requires Two AAA Batteries Included.