Use and Care Manual

MAINTENANCE
Flame
effect/Light bulb replacement:
Allow the electric fireplace insert to cool before attem pting to replace light bulbs. The
flame effect on this elec tric fireplace insert is created by illuminating(2) clear 120V，25watt
E-12(small base, chandelier candle type)light bulbs. The life of the light bulbs will depend
on how often the fireplace is used. Do not use light bulbs that exceed 25 watts per bulb.
1. Turn power to off and unplug insert from electrical outlet before changing light bulbs.
2. Slide f ireplace mantel aw
ay from wal l to gain access to back
of fireplace.
3. Locate access panel on back of insert.
4. Using a Phillips screwdriver, remove screws in access panel. Open door and replace
light bulbs as necessary. It is recommended that both bulbs be replaced at the same
time.
5. Follow steps 1 through 4 in reverse order to reinstall access panel.
NOTE:
NOTE: We do not supply replacement light bulbs. They can
be purchased at many
home centers
or hardware stores.
WARNING:
Before atte mpting to perform any maintenance on this appliance, turn all controls
to
the "OFF" position and the unplug.
llow
Allow the appliance to be "OFF " for at least 10
1
minutes
before
performing any maintenance in order to allow all components to cool properly.