Manual

Before begining, read the instructions below and follow all local
plumbing and building codes.
For this installation of your new freestanding faucet it is presumed
that the water supply lines are underneath the floor and are in
direct access for faucet installation.
A A rounded hole, 1-1/2” in diamter, will provide access to the water
supply lines when mounting the faucet. The distance between the
mounting location to the water supply lines should be
approximately 7”.
Unpack and inspect your new faucet for any shipping damages and
ensure no pieces are missing.
If any damages are discovered DO NOT INSTALL.
SHUT OFF ALL SHUT OFF ALL WATER SUPPLY LINES AT THE TUB W HEN
INSTALLING NEW FAUCET.
Please contact customer service at 1(866)448-Tubs. You may also
call our customer service for any other assistance with out products.
TOOLS AND MATERIALS NEEDED :
Screwdriver Plumberʼs Tape Adjustable wrench
684D
Includes Deck Mounting Kit
Threaded nipple (2) Silver Metal Washer (2) Washer Nut (2)
Gold Washer (2) Rubber Cone Washer (2) Nut (2)
1. Assuming your water lines are prepared.
Locate a threaded nipple, one silver metal washer,
and a washer nut from the deck mounting kit. Slide the
metal washer down the nipple and thread the washer
nut onto the straight end of the nipple.
2. Place 2. Place the threaded nipple through the deck holes in
the tub and tighten the bolt from the water line onto
the straight end of the nipple. Make sure you have a
rubber cone washer and gold ring washer in the nut
before tightening.
3. W ith the tapered end of the nipple protruding
from the tubs deck mount hole, thread one of the
risers onto the nipple as much as possible. Under the
risers, tighten the washer nut to secure the water line
and riser to the tub.
4.Once 4.Once the riser is secure, locate a swing arm and
attach the threaded inlet to the riser and tighten to
secure.
REPEAT STEPS 1 - 4 FOR THE REMAINING RISER &
SW ING ARM
5. Taking only the body of the faucet, attach
the body to both swing arms and center the
body. Tighten the swing arm and faucet
together.
6. Thread the spout onto the top of the faucet
body.
7. Remove the nut behind the spout to show a cone
rubber washer. Thread the stand onto the faucet
body with the rubber cone washer remaining in
the faucet.
8. Attach the short end of the hose to the stand with
the black washer that is tied to the hose. Now
attach the opposite end to the shower wand. Attach
the shower head to the wand as well.
9. Take the three handles and locate the shower
handle. Place and screw this handle onto the
venter of the faucet body. The HOT/COLD
handles will go on the ends of the faucet body.
HOT on the LEFT and COLD on the RIGHT.