Instructions / Assembly

13
OPERATION INSTRUCTIONS
3. Depress control knob and turn knob counter-clockwise
to IGNITE position, then to PILOT position (you will hear
2 clicks).
4. With the pilot light lit, keep control knob depressed
for 30 seconds. (Figure 3)
NOTE: If the pilot light has not ignited, turn heater control
knob to OFF position, fully close gas valve, wait 5 minutes,
then repeat steps 2–4 of the Lighting Instructions.
NOTE: If the pilot light ignites but does not stay lit, turn heater control knob to OFF position, fully close
propane gas valve, wait 5 minutes, then repeat steps 2–3. Now, using a lighter, ignite the pilot light
through the ignition hole on the emitter screen.(Figure 4)
Once the pilot light is lit, depress control knob for 30 seconds.
5. After depressing the control knob for 30 seconds, turn control knob to LOW.
To increase the temperature, turn towards HIGH.(Figure 5)
If you experience any ignition problem please consult “Troubleshooting” on page 17.
Caution: Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning
of oils used in manufacturing will appear. Both smoke and odor will dissipate after approximately 30
minutes. The heater should NOT produce thick black smoke.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner,
turn the control knob to the PILOT position. Then, turn the knob to the level of heat desired.
Figure 3 Figure 4 Figure 5
Normal Abnormal
Note:
In Normal condition,
the height of flame
is 2/3 height of glass
tube under Hi position.
the height of flame is
1/3 height of glass
tube under Low
position.The flame is
stable and bright.
No noise nor black
smoke.Contrarily it is
abnormal condition.
Variable control knob
Pointer
L
O
W
H
I
G
H
P
I
L
O
T
P
u
s
h
t
o
t
u
r
n
O
F
F
I
G
N
I
T
E
OFF
PILOT
HIGH
LOW
LOW
PILOT
OFF
HIGH