Instructions / Assembly

8
ASSEMBLY INSTRUCTIONS
Hardware Used
EE
FF
GG
6-1
6. 6-1.Slide two reflector panels together.
Insert one screw M6 X 10 (FF). Slide one washer 6
(EE) over threaded end of screw M6 X 10 (FF) and
screw on cap nut (GG) loosely.
6-2. Slide reflector plate onto reflector panels.
Insert one screw M6 X 10 (FF). Slide one washer 6
over threaded end of screw M6 X 10 (FF) and screw on
cap nut (GG) loosely. Repeat procedure to complete
the assembly of all four sections. Fully tighten all of
the screws in the rolled edge.
x 9
x 9
x 9
Washer 6
Screw M6 X 10
GG
EE
FF
Cap nuts
6-2
GG
EE
FF
Hardware Used
DD
HH
7 . Support heater. Slide three washers washer 8 (DD )
over threaded end of spacer. Locate reflector assembly
on 3 spacers. Install three washers 8 on spacers and
securely tighten wing nuts (HH) but do not overtighten.
x 6
Washer 8
x 3
Wing nut
7
HH
DD
CC
DD