Instructions / Assembly

BATTERIES
Make sure the control knob is in the "OFF" position. Unscrew
the push button cap on the ignition module located on the
control panel to access the battery compartment. The ignition
module requires one Alkaline AAA size battery (1.5V). The
negative (-) end goes in first. See Figure 13.Dispose of battery
safely. May explode or leak if charged or disposed of in fire.
Make sure of the polarity. Mercury and cadmium free.
Figure 13
LIGHTING INSTRUCTIONS
Warning: If these instructions are not followed exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
1. Open the tank drawer and find the control panel on the left. Make sure the control knob
is in the "OFF" position. See Figure 14. Open the tank valve all the way.
IGNITER BUTTON CONTROL KNOB
2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button
pushed in, push and turn the control knob to the “ON” position. The fire should light
within a few seconds. Once the flame is lit, release the igniter button and continue to hold
the control knob in for 10 to 15 seconds. Release the control knob. The control knob
should pop back out and then remain lit. Note: If the fire does not light, turn the knob to the
“OFF” position and wait five (5) minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to Medium (medium
flame), or Low (small flame).
Figure 14