Instructions / Assembly

INSTALLATION
1.Identify parts packed in carton against the parts list. Remove all protective materials and
set parts on a flat, non-abrasive surface. There must be a minimum of 24 inches of
clearance from the side of the tabletop to any combustible walls
2.Place the tabletop upside-down on a flat, non-abrasive surface. Insert four 1/4"x40 mm
headless bolts (N) into the pre-drilled hole on the underside of the tabletop as shown in
Fig. 3. Do not over tighten.
Figure 3
3.Attach the bottom frame (V) to the bottom frame (U) by using four 1/4"x25 mm bolts (O)
and washers (Q) as shown in Fig 4. Guide bolts through holes in bottom frame, into
pre-drilled holes in the bottom frame. Hand-tighten only.
Figure 4