User Manual

D-POWER
SERIES
BALANCED INPUT
CHANNEL A
12
3
TO CHANNEL A
Sleeve
Tip
Ring
BALANCED INPUT
CHANNEL B
12
3
TO CHANNEL B
Sleeve
Tip
Ring
TO CHASSIS/EARTH
USER MANUAL
D-POWER 05/1
P.13
3.3.2 On/Off Switch
The On/Off Switch is a rocker-type switch. It is located on the right side
of the front panel. To turn the amplifier on, press on the upper part of the
switch. During power up the Clip and Signal LEDs from both channels will
light up in red for a few seconds. To turn the amplifier off, press on the
lower part of the switch.
Amplifier is switched on Amplifier is switched off
The switch initiates a short power supply start-up sequence. After a few
seconds the amplifier is operational.
Disconnect the mains plug from the mains during a lightning storm or
when the amplifier remains unused or unsupervised for a prolonged pe-
riod of time. Alternatively, you can disconnect the amplifier via an external
all-pole disconnection from the mains.
If a power cut occurs while the amplifier is switched on, it will restart
automati cally once the power supply has been restored.
DO NOT REMOVE MAINS CONNECTOR GROUND
IT IS ILLEGAL AND DANGEROUS
3.4 Wiring
3.4.1 Input Connections
XLR: Pin 1 = Ground
Pin 2 = Hot (inphase)
Pin 3 = Cold (out of phase)
Jack: Tip = Hot (inphase)
Ring = Cold (out of phase)
Sleeve = Ground
Always use symmetrical (balanced) shielded cable to connect the
D-POWER amplifier.
3 INSTALLATION