Service manual

Machine Operation Basics
Home Position:
If looking at the underside of the machine from the eject side, look for the Cam Arm and
the proximity sensor located nearby. When the arm is back far enough to interact with the
proximity sensor (the sensor will be lit up) then the machine is in “Home Position.”
In “Home Position” the machine is
looking for a cup with the cup drop
sensor located just under the dial
plate where the cup drops.
If the machine does not detect a cup
in place while the machine is in
“Home Position” then the for the
next 6 cycles the machine logic will
always assume there is not cup in
that index, and as such will not tell
the filler to perform, and will not
place a foil. Adjust the cup drop to
ensure a cup falls into the pocket
just as the table stops moving and it should be read when the machine reaches “Home
Position”
“Home Position” also tells the foil place station to turn the vacuum on for the next foil.
However if there was no cup detected in the pocket that is currently one index away from
Cam Arm
Proximity Sensor
Cup drop Sensor
12