Service manual

Cup Load 101-001-0006

To begin adjustments, remove the cup accumulation cylinders from the top of

the load station.

NOTE: The adjustment screws (Cup Drop Cams) are on one way bearings.

(The screws only manually turn counter-clockwise and not clockwise).

To adjust the screws for proper cup loading, point the leading edge of the screw

(start point of the groove) towards the center of the cup. Each screw should

have its leading edge pointing at the center of the cup.

Place the cup in the adjusted screws and rotate the dial (using the dial jog

feature on the control panel) and watch the cup drop cleanly into the hole in the

dial. Note, the cup should be dropping level, if it is not level, then adjust

individual screws until it is level. Confirm the sensor under the cup has

activated. (Orange light indicated).

The cup should drop into the hole in the dial just after the table stops. There is a

short window of opportunity for the machine to read if there is a cup. If the cup

drops just before the dial plate starts moving again, the sensor under the cup

drop may not read there is a cup until after the Allen Bradley Computer has alrea

Replace accumulation cylinders into housing.