Service manual

Main Controls:

Powering Up:

Ensure lower guards and perimeter guards are in place. Plug power into the machine and

connect the air pressure. Turn the power switch to the “ON” position. The touch screen

should come on and will indicate "Power

Off." Now press the green "E-Stop

Reset" button on the panel above the

"Emergency Stop."

Indicator should now read “Powering

Up” and “E-Stop Reset” button should

now be lit up green.

Next, verify that the machine is in Auto

or Manual Mode.

Manual vs. Auto Mode:

Select “Manual” or “Auto” on the touch screen.

When in “Manual” mode, press and hold “Cycle Start”

to cycle the table. When you release “Cycle Start” the

table will stop. This is useful for slowly positioning and

timing the machine, or for troubleshooting a particular

process during a cycle.

When in “Auto” mode, press “Cycle Start” once to start

cycling the table and “Cycle Stop” to stop cycling the

table. When you press “Cycle Stop” the machine will

continue briefly until the heater head rises off of the

table. This is to prevent the heater head staying down

on a container and seal.

Cycle Speed:

Set the Machine Cycle Speed with the dial. Actual speed is

indicated on the touch screen.

Note: This number will not change

unless the machine is in motion either

“Manual” or “Auto.” This indicator is

a measured cycle rate and the machine must be running to

measure the rate.